THERMOELECTRIC POWER GENERATOR SYSTEMS FOR SALE

THERMOELECTRIC POWER GENERATOR SYSTEMS FOR SALE

THERMOELECTRIC POWER GENERATOR PRODUCTS FOR SALE

Representative of a typical liquid to liquid TEG

LIQUID TO LIQUID TEG POWER GENERATOR

MAXIMUM OPERATING TEMPERATURE HOT SIDE OF 190°C

Click to view Chart on output TEG MODULE

SPECIFICATIONS:

Click on part number for spec sheet:

PART#

TEG2-08-07025HT-SS

spec sheet

@ DT OF 100°C ~ 20 WATTS OUTPUT

@ DT OF 120°C ~ 35 WATTS OUTPUT

@ DT OF 150°C ~ 50 WATTS OUTPUT

TEG2-16-07025HT-SS

spec sheet

@ DT OF 100°C ~ 40 WATTS OUTPUT

@ DT OF 120°C ~ 70 WATTS OUTPUT

@ DT OF 150°C ~100 WATTS OUTPUT

PLEASE CALL FOR PRICING 1-800-769-2395

outside NORTH AMERICA 1-905-751-1362

The above THERMOELECTRIC TEG Power Assembly can be configured to any specific application. If you require a special size or power output we are able to manufacture to any custom requirement.

COLD SIDE PUMP up to 90°C

*******Click TEG ASSEMBLIES LISTED For Pricing*******

Wood Stove TEG Power Generator System.

LIQUID TO HOT FACE TEG POWER GENERATOR

MAXIMUM OPERATING TEMPERATURE HOT SIDE OF 320°C

TEG1 modules are used in these assemblies

SPECIFICATIONS: PART #

TEG1-08-12611-6.0

@ DT OF 100°C ~ 44 WATTS OUTPUT

@ DT OF 120°C ~ 53 WATTS OUTPUT

@ DT OF 150°C ~ 75 WATTS OUTPUT

@ DT OF 180°C ~ 104 WATTS OUTPUT

@ DT OF 210°C ~ 114 WATTS OUTPUT

TEG1-16-12610-5.1

@ DT OF 100°C ~ 35 WATTS OUTPUT

@ DT OF 120°C ~ 42 WATTS OUTPUT

@ DT OF 150°C ~ 54 WATTS OUTPUT

@ DT OF 190°C ~ 69 WATTS OUTPUT

@ DT OF 210°C ~ 82 WATTS OUTPUT

DT = HOT SIDE Temperature MINUS COLD SIDE Temperature

This is a large WOOD STOVE TEG POWER generator. We use ceramic insulation on the opposing side of the hot plate to channel heat thru modules and out to the cold side water sink. The 10"(25cm) x 12"(30cm) heat absorbing anodized Aluminum plate is an ideal size for most wood stove surfaces. The 1/2"(12mm) tubing is ideal for flexible tube hookup. Our thermoelectric wood stove TEG assemblies can be custom built for your specific application. Our large inventory of supporting parts can meet all specific power output requirement and geometry's.

Hot oil to cold liquid heat exchanger. This unit was built using (48) TEG1-12611-6.0.

It is able to produce + 500 watts with a hot side over 250°C and a cold side under 30°C. Custom designs are available Please call for more information.

Size is 22" x 20" x 5" thick.

Click on Image to get full specifications:

This is a new prototype wood stove TEG. It will produce approximately 25-40 watts with a DT of 130°C to 160°C. The heat pipes dissipate more heat then traditional heat sinks, but cannot dissipate as much as a liquid on the cold side. The thermoelectric generator is ideal for designs that cannot use water as a cooling method. The fan can be used to draw cold air from the outside thru a ducting system which would increase power output significantly.

Specifications will be added once we begin production of this unit.

It will available with either:

- 8 pcs TEG1-12610-5.1

- 4 pcs TEG1-12611-6.0

http://www.youtube.com/watchTV= Thermaoelectric Generator heat pipe demonstration with only fan running

http://www.youtube.com/watchTV=Thermoelectric Generator with a fan and light running

Part 1:

http://www.youtube.com/watch?/Difference between TEG and TEC modules

Part 2:

http://www.youtube.com/watch / Differences between TEG and TEC Modules

www.thermoelectric-generator.com

Revised February 4, 2010